Difference between revisions of "How to Factory Reset a Port Authority"

From Tech-Wiki
Jump to: navigation, search
(Created page with "Category:CDI Hard Reset to PA44/PA88 Devices: 1. With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds....")
 
 
(2 intermediate revisions by the same user not shown)
Line 1: Line 1:
 
[[Category:CDI]]
 
[[Category:CDI]]
−
Hard Reset to PA44/PA88 Devices:
+
Hard Reset to PA44/PA88 Devices - this resets the motherboard only (NOT the IP Card):
−
1. With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds.
+
#With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds.
−
2. Release the switch and let the device initialize.
+
#Release the switch and let the device initialise.
−
Hard Reset to PA100/PA200 Devices:
+
#Power cycle the device.
−
1. With the power on and using a paper clip, press in the reset switch located on the front panel of the device.
+
Hard Reset to PA100/PA200 Devices - this resets the motherboard and IP card:
−
2. The ALM LED on the front panel will go on.
+
#With the power on and using a paper clip, press in the reset switch located on the front panel of the device.
−
3. Keep it press in until the ALM LED goes off.
+
#The ALM LED on the front panel will go on.
−
4. Release the reset switch.
+
#Keep it press in until the ALM LED goes off.
−
5. Device is now rebooting (ALM and SEC LEDs are on).
+
#Release the reset switch.
−
6. When the device is finished rebooting the DTM LED and Power LED will be the
+
#Device is now rebooting (ALM and SEC LEDs are on).
−
only LEDS on and there will be no activity on the TXM and RXM LEDS.
+
#When the device is finished rebooting the DTM LED and Power LED will be the only LEDS on and there will be no activity on the TXM and RXM LEDS.

Latest revision as of 08:20, 19 September 2014

Hard Reset to PA44/PA88 Devices - this resets the motherboard only (NOT the IP Card):

  1. With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds.
  2. Release the switch and let the device initialise.
  3. Power cycle the device.

Hard Reset to PA100/PA200 Devices - this resets the motherboard and IP card:

  1. With the power on and using a paper clip, press in the reset switch located on the front panel of the device.
  2. The ALM LED on the front panel will go on.
  3. Keep it press in until the ALM LED goes off.
  4. Release the reset switch.
  5. Device is now rebooting (ALM and SEC LEDs are on).
  6. When the device is finished rebooting the DTM LED and Power LED will be the only LEDS on and there will be no activity on the TXM and RXM LEDS.
Retrieved from ‘http://tech-wiki.net/index.php?title=How_to_Factory_Reset_a_Port_Authority&oldid=388’