Difference between revisions of "How to Factory Reset a Port Authority"
From Tech-Wiki
(Created page with "Category:CDI Hard Reset to PA44/PA88 Devices: 1. With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds....") |
|||
| Line 1: | Line 1: | ||
[[Category:CDI]] | [[Category:CDI]] | ||
Hard Reset to PA44/PA88 Devices: | Hard Reset to PA44/PA88 Devices: | ||
| − | + | #With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds. | |
| − | + | #Release the switch and let the device initialise. | |
Hard Reset to PA100/PA200 Devices: | Hard Reset to PA100/PA200 Devices: | ||
| − | + | #With the power on and using a paper clip, press in the reset switch located on the front panel of the device. | |
| − | + | #The ALM LED on the front panel will go on. | |
| − | + | #Keep it press in until the ALM LED goes off. | |
| − | + | #Release the reset switch. | |
| − | + | #Device is now rebooting (ALM and SEC LEDs are on). | |
| − | + | #When the device is finished rebooting the DTM LED and Power LED will be the only LEDS on and there will be no activity on the TXM and RXM LEDS. | |
| − | only LEDS on and there will be no activity on the TXM and RXM LEDS. | + | |
Revision as of 02:15, 19 September 2014
Hard Reset to PA44/PA88 Devices:
- With the power on and using a paper clip, press in the reset switch located on the front panel of the device for 12 seconds.
- Release the switch and let the device initialise.
Hard Reset to PA100/PA200 Devices:
- With the power on and using a paper clip, press in the reset switch located on the front panel of the device.
- The ALM LED on the front panel will go on.
- Keep it press in until the ALM LED goes off.
- Release the reset switch.
- Device is now rebooting (ALM and SEC LEDs are on).
- When the device is finished rebooting the DTM LED and Power LED will be the only LEDS on and there will be no activity on the TXM and RXM LEDS.