View source for Cluster commands

[[Category:Fortinet]]

Setting FGCP Cluster up (active passive)
 config system ha
    set mode a-p
    set group-name cluster1
    set password abc123
    set hbdev port4 100
 end

Setting FGSP Cluster (Session Sync)
 config system ha
    set group-name cluster1
    set password abc123
    set session-sync-dev port5
    set session-pickup enable
    set session-pickup-connectionless enable
    set session-pickup-expectation enable
    set session-pickup-nat enable
    set standalone-config-sync enable
 end

Monitor cluster health and sync
 get sys ha status
 diag sys ha checksum show (each unit or diag sys ha checksum cluster in one)
 diag sys session sync

If something above is wrong, try:
  diag sys ha checksum recalculate
  exec ha synchronize start  (only in the slave)

Switch to manage the slave unit:
  exec ha manage 0