Difference between revisions of "Setting Proxy ARP entries for Manual NATs"
From Tech-Wiki
(Created page with "Category:Check Point If your recently created manual NAT is not working, maybe you need to create manually proxy ARP entries. To do so, edit the file $FWDIR/conf/local.ar...") |
|||
| Line 4: | Line 4: | ||
To do so, edit the file $FWDIR/conf/local.arp (or in VSX environments $FWDIR/CTX/CTX000<VSID>/conf/local.arp) | To do so, edit the file $FWDIR/conf/local.arp (or in VSX environments $FWDIR/CTX/CTX000<VSID>/conf/local.arp) | ||
| − | The | + | The new line should look like this one below, where the MAC address should be the virtual MAC used by the security gateway on the incoming interface: |
192.168.10.100 00:1C:7F:82:01:FE | 192.168.10.100 00:1C:7F:82:01:FE | ||
Revision as of 19:08, 10 July 2016
If your recently created manual NAT is not working, maybe you need to create manually proxy ARP entries.
To do so, edit the file $FWDIR/conf/local.arp (or in VSX environments $FWDIR/CTX/CTX000<VSID>/conf/local.arp)
The new line should look like this one below, where the MAC address should be the virtual MAC used by the security gateway on the incoming interface:
192.168.10.100 00:1C:7F:82:01:FE