Difference between revisions of "Useful commands"
From Tech-Wiki
| (2 intermediate revisions by the same user not shown) | |||
| Line 14: | Line 14: | ||
Getting system information: | Getting system information: | ||
show system info | show system info | ||
| + | show system logdb-quota | ||
Getting performance status: | Getting performance status: | ||
| Line 56: | Line 57: | ||
To validate if the candidate version is consistent (validating syntax and semantics): | To validate if the candidate version is consistent (validating syntax and semantics): | ||
| − | validate full | + | > configure |
| + | # validate full | ||
| + | > show jobs id xxxx | ||
To commit even with errors: | To commit even with errors: | ||
Latest revision as of 21:22, 25 May 2021
Executing ping/traceroute:
ping host xxx.xxx.xxx.xxx traceroute host xxx.xxx.xxx.xxx
To get interfaces and MAC address:
show interface all show arp all
Display routing table:
show routing route
Getting system information:
show system info show system logdb-quota
Getting performance status:
show system statistics session (Throughput) show system resources (Top equivalent) show running resource-monitor (Historical)
Sample log filter examples to use in GUI:
(addr.src in 192.168.1.10) and (port.dst eq 21) (from/member eq 'trust') and (source/member eq 'Host1')
Reading the system log:
less mp-log master.log
Validate if specified traffic will match any firewall/nat rule
test security-policy-match from trust to untrust source 10.4.70.48 destination 200.1.2.100 destination-port 80 protocol 6 test nat-policy-match source 10.1.0.1 destination 200.1.2.100 destination-port 21 protocol 6
To view current host objects based on FQDN or to update the list:
show dns-proxy fqdn all request system fqdn show request system fqdn refresh force yes
Display current connections through the firewall and get detailed info for a specific one:
show session all filter state active show session id xxxxx
Filtering and closing active connections:
show session all filter source x.x.x.x show session all filter application xxxxxx clear session id xxxxx
Change the virtual system
set system setting target-vsys ?
To commit the candidate version of configuration:
commit partial vsys vsys1 device-and-network excluded
Check pending changes:
Click on the Device tab > Config audit Select a candidate config on the right
To validate if the candidate version is consistent (validating syntax and semantics):
> configure # validate full > show jobs id xxxx
To commit even with errors:
commit force
Troubleshoot IPSec VPN issues:
show vpn gateway show vpn ike-sa debug ike global on debug less mp--log ikemgr.log
Reboot/Shutdown the device
request restart/shutdown system On GUI click on Device tab > Setup link > Operations tab