Difference between revisions of "EtherChannel"
From Tech-Wiki
(Created page with " Switch1# configure terminal Switch1(config)# interface range FastEthernet0/11 -12 Switch1(config-if-range)# switchport mode access Switch1(config-if-range)# switchport a...") |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| + | [[Category:Cisco Systems]] | ||
| + | |||
| + | The command below allows to create a Port Aggregation on Cisco devices (EtherChannel) | ||
| + | |||
Switch1# configure terminal | Switch1# configure terminal | ||
| − | Switch1(config)# interface range FastEthernet0/11 -12 | + | Switch1(config)# interface range FastEthernet0/11 - 12 |
Switch1(config-if-range)# switchport mode access | Switch1(config-if-range)# switchport mode access | ||
Switch1(config-if-range)# switchport access vlan 10 | Switch1(config-if-range)# switchport access vlan 10 | ||
Switch1(config-if-range)# channel-group 5 mode desirable | Switch1(config-if-range)# channel-group 5 mode desirable | ||
Latest revision as of 14:45, 7 September 2017
The command below allows to create a Port Aggregation on Cisco devices (EtherChannel)
Switch1# configure terminal Switch1(config)# interface range FastEthernet0/11 - 12 Switch1(config-if-range)# switchport mode access Switch1(config-if-range)# switchport access vlan 10 Switch1(config-if-range)# channel-group 5 mode desirable