Difference between revisions of "Setting Proxy ARP entries for Manual NATs"
From Tech-Wiki
| (One intermediate revision by the same user not shown) | |||
| Line 11: | Line 11: | ||
After applying the policy, validate using: | After applying the policy, validate using: | ||
| + | |||
| + | fw ctl arp | ||
| + | |||
| + | The Equivalent of that using Gaia would be: | ||
| + | |||
| + | add arp proxy ipv4-address 192.168.10.100 interface eth0 | ||
| + | |||
| + | And check with: | ||
show arp proxy all | show arp proxy all | ||
Latest revision as of 21:54, 9 August 2016
If your recently created manual NAT is not working, maybe you need to create manually proxy ARP entries.
To do so, edit the file $FWDIR/conf/local.arp (or in VSX environments $FWDIR/CTX/CTX000<VSID>/conf/local.arp)
The new line should look like this one below, where the MAC address should be the virtual MAC used by the security gateway on the incoming interface:
192.168.10.100 00:1C:7F:82:01:FE
After applying the policy, validate using:
fw ctl arp
The Equivalent of that using Gaia would be:
add arp proxy ipv4-address 192.168.10.100 interface eth0
And check with:
show arp proxy all