Difference between revisions of "Expand disks using Diskpart"
From Tech-Wiki
| Line 2: | Line 2: | ||
'''[[Microsoft#Misc|Back to Misc]]''' | '''[[Microsoft#Misc|Back to Misc]]''' | ||
| − | <nowiki> | + | <nowiki> |
DISKPART > Select Disk 0 ("This assumes that DISK 0 is your boot disk") | DISKPART > Select Disk 0 ("This assumes that DISK 0 is your boot disk") | ||
Disk 0 is now the selected disk. | Disk 0 is now the selected disk. | ||
Revision as of 19:21, 26 June 2018
DISKPART > Select Disk 0 ("This assumes that DISK 0 is your boot disk")
Disk 0 is now the selected disk.
DISKPART > Detail Disk
Controller Type SCSI Disk Device
Disk ID: 2FE43460
Type : SCSI
Bus : 3
Target : 0
LUN ID : 0
Volume ### Ltr Label Fs Type Size Status Info
---------- --- ----------- ----- ---------- ------- --------- --------
Volume 1 C NTFS Partition 68 GB Healthy System
DISKPART > Select Volume 1
Volume 1 is the selected volume.
DISKPART > Extend Size=10000 ("10000 will expand the disk by 10GB as an example, if no size is specified all available space will be allocated to the partition") Disk Part successfully extended the volume.
DISKPART > Exit