Difference between revisions of "Expand disks using Diskpart"
From Tech-Wiki
| Line 16: | Line 16: | ||
LUN ID : 0 | LUN ID : 0 | ||
| − | Volume ### Ltr Label Fs Type Size Status Info | + | Volume ### Ltr Label Fs Type Size Status Info |
| − | + | ---------- --- -------- ----- ---------- ------- --------- -------- | |
| − | Volume 1 | + | Volume 1 D Data NTFS Partition 68 GB Healthy System |
DISKPART > Select Volume 1 | DISKPART > Select Volume 1 | ||
Revision as of 19:24, 26 June 2018
In example below it will expand the disk by 10GB, if no size is specified all available space will be allocated to the partition. Keep in mind that Windows 2003 doesn't allow to expand system volume.
DISKPART > Select Disk 0 ("This assumes that DISK 0 is your boot disk")
Disk 0 is now the selected disk.
DISKPART > Detail Disk
Controller Type SCSI Disk Device
Disk ID: 2FE43460
Type : SCSI
Bus : 3
Target : 0
LUN ID : 0
Volume ### Ltr Label Fs Type Size Status Info
---------- --- -------- ----- ---------- ------- --------- --------
Volume 1 D Data NTFS Partition 68 GB Healthy System
DISKPART > Select Volume 1
Volume 1 is the selected volume.
DISKPART > Extend Size=10000
Disk Part successfully extended the volume.
DISKPART > Exit