Difference between revisions of "Setting Proxy ARP entries for Manual NATs"
From Tech-Wiki
| Line 12: | Line 12: | ||
After applying the policy, validate using: | After applying the policy, validate using: | ||
| − | show arp proxy all | + | show arp proxy all ''or'' |
| + | fw ctl arp | ||
Revision as of 21:53, 9 August 2016
If your recently created manual NAT is not working, maybe you need to create manually proxy ARP entries.
To do so, edit the file $FWDIR/conf/local.arp (or in VSX environments $FWDIR/CTX/CTX000<VSID>/conf/local.arp)
The new line should look like this one below, where the MAC address should be the virtual MAC used by the security gateway on the incoming interface:
192.168.10.100 00:1C:7F:82:01:FE
After applying the policy, validate using:
show arp proxy all or fw ctl arp