Expand disks using Diskpart
From Tech-Wiki
Revision as of 19:03, 26 June 2018 by Fabricio.Lima (Talk | contribs) (Created page with "Category:Microsoft '''Back to Misc''' DISKPART > Select Disk 0 ("This assumes that DISK 0 is your boot disk") Disk 0 is now the selected disk. DISKPA...")
DISKPART > Select Disk 0 ("This assumes that DISK 0 is your boot disk")
Disk 0 is now the selected disk.
DISKPART > Detail Disk
Controller Type SCSI Disk Device Disk ID: 2FE43460 Type : SCSI Bus : 3 Target : 0 LUN ID : 0
Volume ### Ltr Label Fs Type Size Status Info
---------- --- ----------- ----- ---------- ------- --------- -------- Volume 1 C NTFS Partition 68 GB Healthy System
DISKPART > Select Volume 1
Volume 1 is the selected volume.
DISKPART > Extend Size=10000 ("10000 will expand the disk by 10GB as an example, if no size is specified all available space will be allocated to the partition") Disk Part successfully extended the volume.
DISKPART > Exit