Dynamic routing commands

From Tech-Wiki
Revision as of 16:03, 11 July 2016 by Fabricio.Lima (Talk | contribs) (Created page with "Category:Fortinet Get dynamic routing info: get router info bgp network get router info bgp summary get router info bgp neighbors get router info ospf status get rou...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Get dynamic routing info:

get router info bgp network
get router info bgp summary
get router info bgp neighbors
get router info ospf status
get router info ospf summary

In order to advertise non-local routes to BGP peers, it's required to define them in the local routing table as blackhole

 config router bgp
  config network
   edit 0
    set prefix 10.0.0.0/8
  end
 end
 config router static
  edit 0
   set dst 10.0.0.0 255.0.0.0
   set blackhole enable
  next
 end

Redistribute default route (cisco default-information originate | neighbor xxx default-originate)

 config router ospf
  set default-information-originate enable
 config router bgp
   config neighbor
     set capability-default-originate enable

Influence outbound routing preference

 config router map
  edit ISP1-pref
  config rule
   edit 10
    set set-local-preference 50
   end
  end
 config router bgp
  config neighbor
   edit 200.0.0.1
    set route-map-out ISP1-pref
   end
 end
# exec router clear bgp ip 200.0.0.1 soft out